Installation of the heater
.
The Mikuni MY series heaters are blown air diesel fired heaters running off either a
12
or
24
volt DC supply
.
To ensure good service from your heater it is important to install it correctly
paying attention to all the details laid out
within this instruction leaflet
.
Planning the Installation
Take time to plan your installation
!
The heater should be sited in an area where
:
(i
)
It will not have items stored against it.
(
ii
)
It will not be exposed to weather
.
(
iii
)
It is within the parameters set out in this manual regarding fuel and power supply.
(
iv
)
It is within the parameters set out in this manual regarding heater mounting
.
(v
)
The exhaust outlet skin fitting is well clear of the water line.
(
vi
)
The exhaust pipe is not touching anything inside the boat which could be damaged by
heat
-The exhaust pipe does get hot even though it is insulated!
Tools for your installation
:
Here is a list of some of the tools required to help with your installation
:
1.
Electric drill with slow speed
.
2.
Crimping pliers
.
3.
Wire cutters
.
4.
Metric spanners
8
mm to
13
mm
.
5.
Flat blade
& posidrive screwdrivers.
6
.
Sharp knife
.
Application
Hot air outlets
Ducting
Skin fitting
Fuel standpipe
MY
16
95
mm
60
mm
42
mm
22
mm
MY
30
95
mm
90
mm
42
mm
22
mm
Hole saws
-
1
-
To Next Page
Need help?
General