Directions for SafetyWand™ Use:
1. Remove the handpiece (with attached needle) from the cap on side of the
drive unit. Protract the needle by depressing the back portion of the
control tab, gently sliding it forward all the way (Fig. 7), and depressing the
forward portion of control tab to lock into the protracted position (Fig. 8).
The control tab becomes “self-locked” into the protracted position.
Perform the injection.
Fig. 7 Fig. 8
2. To retract the needle using one hand, depress the back portion of
control tab with your finger or thumb. This will automatically retract the
needle into the safety position. You will hear and see the control tab and
needle “lock” in the retracted safety position (Fig. 9, 10).
To Retract: Fig. 9
Fig. 10
- 9 -
To Next Page
Loading...
