Auto-retraction:
The needle will automatically retract when released from the protracted position.
3. Place the handpiece on the side of the drive unit when not in use. While
still in the retracted state and using the needle cap as a guide, slide the
handpiece into the cap on the side of the drive unit.
Disposal:
1. After last injection, withdraw needle from tissue and retract into the back
position.
2. Press down firmly on the front end of the control tab with your thumb-nail
and push it into the sleeve
3. Press hard enough to make the forward portion of the control tab “break-
through”, lodging itself into the sleeve. This will prevent the handpiece
from protracting.
Fig. 11
4. Directly discard in an approved manner, e.g., a sharps container.
CAUTION: Do not use with needles longer than 1.25 inches with the
SafetyWand™.
CAUTION: Maintain sterile conditions.
- 10 -
To Next Page
Loading...
