Millarco 62.090 - Page 33

PROBLEM MULIG ÅRSAG AFHJÆLPNING/
HANDLING
Engine will not start 5. Starter cord pulls
harder now than when
new.
5. Contact an authorised
service dealer.
Engine does not reach
full speed
1. Check oil fuel mixture 1. Use fresh fuel and the
correct 2 stroke oil mix.
2.Airlterisdirty. 2.Cleartheairlter.
3. Spark arrestor screen
is dirty.
3. Clean the spark plug
arrestor.
Linewillnotadvance
when using automatic
line lengthening
1.Lineweldedtoitself. 1.Lubricatewithsilicone
spray.
2. Not enough line on
the spool.
2. Install more line.
3.Lineworntooshort. 3. Pull line while alter-
nately pressing down on
and releasing the retain-
ing cap.
4.Linetangledonspool. 4. Remove line from
spool and rewind.
5. Engine speed too
slow.
5.Advancelineatfull
throttle.
Retaining cap hard to
turn when using auto-
matic line lengthening
Screw threads are dirty
or damaged.
Clean the threads and
lubricate with grease. If
this does not solve the
problem, replace the
retaining cap.
Grass wraps around the
trimmer head assembly
and the attachment
shaft
1. Cutting tall grass at
ground level.
1. Cut tall grass from
the top down.
2. Operating the product
at
part throttle.
2. Operate the product
at full throttle.
Oildripsfrommufer
1. Operating the product
at part throttle.
1. Operate the product
at full throttle.
2. Check oil/fuel mix-
ture.
2. Use fresh fuel and the
correct 2 stroke oil mix.
3.Airlterisdirty. 3.Cleantheairlter.