1. Press [MODE] repeatedly until the [KIT] LED lights up.
ð
The display shows the kit number.
2. Press [PAGE].
ð
The kit volume appears in ‘Lxx’ format on the display.
3. Use [–] and [+] to adjust the volume in a range between 00 and 32.
The setting is automatically stored.
To turn the Reverb eect on or o, proceed as follows:
1. Press [MODE] repeatedly until the [KIT] LED lights up.
ð
The display shows the kit number.
2. Press [PAGE].
ð
The current Reverb setting appears in the display ( ‘roN’ : on or ‘roF’ : o).
3. Change the setting using [–] and [+].
The setting is automatically stored.
Adjusting kit volume
Turning Reverb on / o
Operating
MPS-150X
25
E-Drum Module
To Next Page
Loading...
Need help?
General
