Press the [CLICK] button to activate or deactivate the metronome.
You may adjust the click speed at any moment by means of the [–] / [+] buttons.
1. Press the [TEMPO] button. The current click speed appears on the display.
2. Using the [–] / [+] buttons, set the click speed to any desired value between
‘40’ and ‘240’.
To reset the click speed to its default value (120 bpm), simultaneously press
the [–] / [+] buttons.
The drum module offers you the possibility of recording a pattern of your own and
saving it as pattern no. ‘051’ on the device. The recording can be done with or
without accompaniment pattern. When recording with an accompaniment pattern,
you can mute the included drum track ([DRUM OFF] button).
Recording without accompaniment pattern
1. Press the [RECORD] button to activate the recording mode.
ð
The signal LED of the [RECORD] button starts flashing. The number of the
first pattern appears on the display. Press the [PATTERN] button to record
without accompaniment (‘oFF’ message).
2. Start recording by striking a pad (synchro start).
ð
The signal LED of the [RECORD] button lights up.
3. Terminate your recording by pressing the [STOP] button.
ð
The signal LED of the [RECORD] button goes out.
Recording with accompaniment pattern
1. Press the [RECORD] button to activate the recording mode.
ð
The signal LED of the [RECORD] button starts flashing. The number of the
first pattern appears on the display.
2. Use the [–] / [+] buttons to select the desired accompaniment pattern.
3. Adjust the pattern volume and pattern speed (see ).
4. Start recording by pressing the [RECORD] button (auto start with one 4/4 bar
pre-count).
ð
The signal LED of the [RECORD] button lights up. The pattern will be played
back in an endless loop until you terminate playback by pressing the
[STOP] button and the signal LED of the [RECORD] button goes out.
Metronome
Recording function
Operation
e-drum set
20
To Next Page
Loading...
Need help?
General
