Millenium MPS-750X - Page 27

Parameter Function
Sensitivity The touch sensitivity regulates the volume behaviour of a pad regardless of the actual strike
intensity. The higher the value, the higher the volume when playing, and vice versa.
Headroom This parameter is used to preset the level reserve between normal and maximum level when
playing the pads.
SenseTime Presetting the minimum time interval between two signals from the same trigger prevents
unwanted sound overlays by vibrations.
Trigger The trigger curve regulates the velocity, i.e. the ratio between the punch and volume. Use set‐
ting ‘Linear’ for the most natural ratio between punch and volume. Use ‘Exp’ if you want a
hard strike to cause a bigger volume change (or dynamics). Use ‘Log’ if you want a soft strike
to cause a bigger change. With the setting ‘Spline’ the volume changes less upon a change of
the strike. High volumes are already reached at a relatively low strike intensity.
Peak Decay Setting the time period how long after signal input of the selected pad no other signal is
accepted. The higher the value is, the lower the likelihood that notes are skipped, but double
triggering is easier.
Rim/Head
Modier
Improve signal detection by increasing the signal strength dierence between rim and head.
The Rim Modier strengthens the rim signal when the touch velocity is low. The Head Modi‐
er lowers the head signal when the touch velocity is low.
This setting only needs to be adjusted if pads of other models or manufacturers are used, but
not if the original pads are used.
Operating
MPS-750X, MPS-750X PRO
27
E-Drum Module