To Next PageTo Next Page
Need help?Do you have a question about the Millennium L220 and is the answer not in the manual?
General| Brand | Millennium |
|---|---|
| Model | L220 |
| Category | Hunting Equipment |
| Language | English |
Introduces the ladderstand and highlights strict weight limits for user and equipment.
Emphasizes viewing the included Safe Treestand Hunting video before use.
Provides contact information for questions and assistance with Millennium products.
Stresses the importance of paying attention to all "WARNING!" messages for personal safety.
Outlines user and owner responsibilities for safe operation and instruction sharing.
Requires carrying an operable signaling device for emergency assistance.
Recommends annual review of manual and safety video for continued safe practices.
Prohibits use if physical impairments limit safe operation or if ill.
Emphasizes following installation and maintenance instructions to prevent injury.
Requires using a factory-provided or equivalent full-body fall arrest harness.
Inspect treestand and safety devices for wear, damage, or defects before each use.
Strictly adhere to weight limits and avoid platform jumping; check hardware.
Avoid use during adverse weather like thunderstorms, ice, or snow.
Use genuine parts; wear appropriate footwear for safety.
Use trees with a minimum 9-inch diameter; requires three adults for installation.
Maintain three-point contact; lean forward; use FAS at all times.
Practice FAS setup and use at ground level before using at heights.
Keep lanyard snug, above head; avoid neck entanglement to prevent choking hazards.
Remain calm if a fall occurs; have a plan and avoid panic.
Develop a self-recovery plan; do not hunt if physically unable to self-recover.
Identifies FAS parts, specifies 300 lb capacity, and mandates 3-year replacement.
Use approved FAS, store properly to prevent damage from environmental factors.
Option to use aftermarket FAS if needed; always comply with weight capacity.
Detailed steps for putting on the FAS harness correctly.
Adjust waist and leg loops snugly, avoiding overtightening to maintain circulation.
Crucial instruction to thread the tree belt buckle correctly to prevent failure.
Adjust tether length to minimize fall distance, considering user position.
SRD relieves pressure on lower extremities during suspension; must be accessible.
Steps to deploy and use SRD to stand or call for help after a fall.
Correct prusik hitch setup is mandatory for safety; misuse can cause falls.
For single use, hunting only; read all warnings before attempting use.
Descend by sliding prusik hitch down, keeping it above head for safety.
Climb by sliding prusik hitch up, maintaining three points of contact.
Position prusik hitch high on the tree to limit potential fall distance.
Specific instructions for two users to ascend and descend safely with the system.
Guidelines for when to replace the climbing rope system due to wear or damage.
Identifies all parts for the L220 18' Double Ladderstand assembly.
Strict weight limit of 15 lbs for footrest and shooting rail to ensure safety.
Steps for joining platform sections and attaching hinges to the seat frame.
Install adjusters, tree blade, and attach platform to uprights.
Install vertical supports and connect them to seat hinges.
Assembling and installing the shooting rail and footrest.
Pinning ladder sections together with spring pins and engaging spring clips.
Practice setup at ground level; always wear the full-body fall arrest harness.
Avoid single safety belts, climbing utility poles, or near power lines.
Restrictions for users with health issues or taking impairing medications.
Avoid adverse weather, use only by adults, unload weapons during climbing.
Use trees 12"-22" diameter; requires three adults for installation.
Attach stabilizing straps to ladder adapters and secure tree belt.
Clear area around tree; place bottom ladder section on level ground.
Erect treestand with assistance, centering tree blade, and angling ladder 15 degrees.
Ensure bottom rung is flush; tighten straps and tree belt securely.
Climb, attach tether to tree, and secure stand with ratchet straps.
Follow safety steps for removal, including wearing FAS and leaning forward.
Disconnect tether, remove straps, disassemble, and lower treestand safely.
Store treestand out of direct sunlight and harsh environmental conditions.
Details one-year warranty, proof of purchase, and contact for service.
