Miller Weldmaster Extreme T300

To Next Page

Instruction Manual

Page 1

This instruction manual is intended to be a guide when operating the T300 Extreme Seam welder. To

ensure optimal performance from your welder, please follow the recommendations and specifications

precisely.

For more technical information regarding this machine call our Resolution Center at 1-855-888-WELD or

email service@weldmaster.com.

You can also subscribe to Miller Weldmaster Insiders to stay updated on tech tips, machine maintenance

updates, and more at www.weldmaster.com/insiders.

Need help?

Do you have a question about the Miller Weldmaster Extreme T300 and is the answer not in the manual?

Summary

Details the main user interface, including recipe, speed, and temperature settings.

Details amp rating, power, voltage, temperature, speed, dimensions, and weight.

Details operator interface, buttons, and pneumatic system components.

Guides for replacing the heat element, wedge tip, HMI battery, and PLC battery.

Covers hot air and hot wedge heat system adjustments, and roller speed settings.

Lists requirements for air pressure, roller pressure, lifting, alignment, and leaks.

General

Model	Extreme T300
Welding Method	Hot Wedge
Material Thickness	Up to 2mm
Power Supply	208-240 VAC \| Three Phase \| 50/60 Hz
Electrical Requirements	208-240 VAC \| Single Phase \| 50/60 Hz 208-240 VAC \| Three Phase \| 50/60 Hz 380-480 VAC \| Three Phase \| 50/60 Hz
Air Requirements	80 psi
Welding Speed	Up to 40 ft/min (12 m/min)
Heating System	Hot Wedge
Power Requirements	208-240V, 3 Phase
Air Supply	80 psi