Miller Weldmaster T-100

Need help?

Do you have a question about the Miller Weldmaster T-100 and is the answer not in the manual?

Summary

Chapter 1: Machine Overview

Section 1.1: Intended Use

Section 1.2: Electrical and Air Requirements

Specifies power voltage, frequency, amperage, and shop air supply needs.

Section 1.3: Principles of Heat Sealing

Section 1.6: Controls: Purposes and Functions

Describes the operational purpose and function of each machine control.

Chapter 2: Heating System Overview and Adjustments

Section 2.1: Hot Air Heating System

Details hot air nozzle placement, angle, height, and depth adjustments.

Section 2.2: Wedge Adjustment

Provides procedures for adjusting wedge height, squareness, tilt, and pressure.

Chapter 3: Changing Heating Systems

Section 3.1: Changing from Hot Air to Hot Wedge

Step-by-step instructions for replacing the hot air system with a hot wedge.

Section 3.2: Changing from Hot Wedge to Hot Air

Step-by-step instructions for replacing the hot wedge system with hot air.

Chapter 4: Operating Procedures

Section 4.1: Start Up

Section 4.2: Shut Down

Chapter 7: Maintenance

Routine Maintenance Procedures

Component Replacement Guide