What to do if Miller Scrubber discharges fumes or particles?
If your fume extractor discharges fumes or particles, inspect the filter (including the gasket) and replace it if it's damaged or dirty. Make sure the filter is installed correctly.
What to do if the filter cleaning system does not operate on Miller Scrubber?
If the filter cleaning system isn't working, check fuse F1 and replace it if it's open.
What to do if my Miller Scrubber discharges fumes or particles?
If your Miller Scrubber discharges fumes or particles, inspect the filter (including the gasket) and replace it if it is damaged or dirty. Make sure that the filter is installed properly.
Why is the air flow decreased in my Miller Scrubber?
Decreased air flow can occur for several reasons. You can try the following: - Reconnect the extraction arm flexible tubing. - Inspect the extraction arm tubing and replace it if damaged. - Remove any obstructions from the fume extraction arm. - Clean or replace the filter. - You can also have a Factory Authorized Service Agent check for correct fan rotation (counterclockwise as viewed from top).
What to do if the motor/blower will not start on my Miller Scrubber?
If the motor/blower won't start, you can try the following: - Check the input power connection. - Reset circuit breaker CB1. - If the issue persists, have a Factory Authorized Service Agent check the motor and wiring.
How to fix Miller Scrubber extraction arm that does not stay in position?
If the extraction arm doesn't stay in position, try adjusting the extraction arm joints.
How to clean Miller Scrubber extraction arm that does not turn easily?
If the extraction arm doesn't turn easily, clean the swivel base bearings.
What to do if the motor/blower will not start in my Miller FILTAIR MWX-S?
If the motor/blower of your Miller Scrubber does not start or continue running, you can try the following: * Check the input power connection. * Reset Circuit Breaker CB1. If the problem persists, have a Factory Authorized Service Agent check the motor and wiring.
How to fix a Miller FILTAIR MWX-S Scrubber extraction arm that does not stay in position?
If the extraction arm of your Miller Scrubber does not stay in position, adjust the extraction arm joints.
What to do if the filter cleaning system does not operate in Miller FILTAIR MWX-S?
If the filter cleaning system does not operate in your Miller Scrubber, check fuse F1 and replace it if it's open.
Explains the meaning of symbols used in the manual for hazard identification and warnings.
Details specific risks and precautions associated with operating the fume extractor.
Outlines potential dangers when performing arc welding and plasma cutting processes.
Covers additional safety symbols and related hazards for equipment setup, use, and upkeep.
Provides specific warnings about chemicals known to cause cancer or birth defects.
Lists key industry standards and organizations relevant to welding and cutting safety.
Explains electromagnetic fields and their potential effects on medical implants.
General| Model | FILTAIR MWX-S |
|---|---|
| Category | Scrubber |
| Filtration Type | HEPA |
| Power Source | Electric |
| Motor Power | 1.5 HP |
| Filter Efficiency | 99.97% at 0.3 microns |
| Input Power | 120V/60Hz |
To Next Page
