milliard GOLF ORGANIZER

To Next Page

STOP : Please read the following

instructions entirely before attempting to

assemble or use the organizer for the first

time. Failure to follow assembly instructions

may lead to damage or injury.

WARNING:

• This product is for golf equipment only

• Do not use a partially-assembled organizer

• Not intended for commercial use

• Do not exceed total weight capacity of 150lbs

• Do not use organizer if damaged

• Perform assembly on a flat, level surface

If any parts are missing or defective contact us at info@milliardbrands.com or call 866.686.4891

STOP

GOLF ORGANIZER

Congratulations on the purchase of your new Milliard™ Golf Organizer! With so many

accessories available to drive your drivers and perform the perfect putt, this handy rack

will keep all of your golf equipment in one place, neatly ordered and ready to hit the greens.

Golf Organizer

ASSEMBLY

Position the foam tape-side of the upper back panel (3)

facing the inside of the assembly as shown and secure

it to the left, center, and right-side panels with three

long screws and nuts.

Insert the bottom (8), middle (7),

and top (6) shelves by placing

them on the corresponding shelf

brackets provided on the middle

and right side panels. Place the

notched side of each shelf toward

the back for proper installation.

Attach the top shelf face (9) to the

middle panel and the right panel

by using three long screws and

nuts.

Lay the assembly on its back and attach the front brace

(11) to the side panels with short screws (15) and nuts

(13) just above the bottom panel as shown.

Attach the four foot pads (14) at each of the bottom

corners, and then stand the assembly upright.

FRONT BASE

FOOT PADS

BOTTOM SHELF

MIDDLE SHELF

TOP SHELF

TOP SHELF FACE

UPPER BACK PANEL

FOAM TAPE LOCATION

Need help?

Do you have a question about the milliard GOLF ORGANIZER and is the answer not in the manual?

Summary

Golf Organizer Assembly Steps

Step 5: Attach Upper Back Panel

Position foam tape-side of the upper back panel facing inside and secure to side panels with screws and nuts.

Step 6: Insert Shelves

Insert bottom, middle, and top shelves onto shelf brackets with notched side toward the back.

Step 7: Attach Top Shelf Face

Attach the top shelf face to the middle and right panels using screws and nuts.

Step 8: Attach Front Brace and Foot Pads

Attach front brace to side panels and foot pads to bottom corners, then stand upright.

Golf Organizer Assembly and Parts

Step 1: Secure Lower Back Panel

Position bottom panel with mesh side up and secure lower back panel with screws and nuts.

Step 2: Position Left Panel

Position left panel with foam side facing inward and secure to base and lower back panel.

Step 3: Position Middle Panel

Position middle panel with foam tape facing left panel and secure to base and lower back panel.

Step 4: Position Right Panel

Position right panel on the right side and secure to the base and lower back panel.

Overview

Function Description
Important Technical Specifications
Usage Features
Maintenance Features
Assembly Instructions and Safety Warnings
Important Safety Warnings and Recommendations

The Milliard Golf Organizer is a storage solution designed to keep all golf equipment neatly organized and readily accessible. It is intended for personal use and is not suitable for commercial applications.

Function Description:

The primary function of the Milliard Golf Organizer is to provide a dedicated and structured storage space for various golf accessories, including drivers, putters, and other equipment. By centralizing golf gear, it aims to simplify preparation for a round of golf and maintain order within a storage area. The organizer features multiple shelves and compartments to accommodate different types and sizes of golf items.

Important Technical Specifications:

Weight Capacity: The organizer has a total weight capacity of 150 lbs. This limit should not be exceeded to prevent damage or injury.
Assembly: The product requires assembly, which involves attaching various panels, shelves, and braces using screws and nuts.
Materials: While specific material types are not detailed, the components include metal panels, shelves, and braces, along with foam tape for certain panel placements. Foot pads are included for stability and floor protection.
Dimensions (Assembled): The exact assembled dimensions are not provided in the manual, but the diagrams suggest a freestanding unit with multiple vertical shelves and a front brace for structural integrity.

Usage Features:

Dedicated Storage: The organizer is specifically designed for golf equipment, ensuring that items like drivers, putters, and other accessories have designated spots.
Multiple Shelves: It includes a bottom shelf, middle shelf, and top shelf, each with a notched side intended to face the back for proper installation. These shelves are supported by brackets on the middle and right side panels.
Top Shelf Face: A separate top shelf face component enhances the aesthetic and functional design of the top shelf.
Front Brace: A front brace is included to provide additional stability to the assembled unit.
Foot Pads: Four foot pads are attached to the bottom corners of the assembly to protect the floor and provide stability.
Easy Access: The open design of the shelves allows for easy access to stored equipment.

Maintenance Features:

The manual does not explicitly detail maintenance features. However, based on the product's nature, general maintenance would likely involve:

Regular Cleaning: Wiping down surfaces to remove dust and debris.
Inspection: Periodically checking all screws and nuts to ensure they remain tight and secure.
Damage Assessment: Not using the organizer if it is damaged, as this could compromise its structural integrity and safety.
Weight Management: Adhering strictly to the 150 lbs weight capacity to prevent strain on the structure and potential damage.

Assembly Instructions and Safety Warnings:

The manual provides detailed, step-by-step assembly instructions with accompanying diagrams. Key assembly steps include:

Preparation: Unpacking all components and verifying against the parts list. Positioning the bottom panel with the mesh side up and attaching the lower back panel.
Left Panel Attachment: Securing the left panel (foam side facing inward) to the base and lower back panel using long screws and nuts.
Middle Panel Attachment: Positioning and securing the middle panel (foam tape facing the left panel) to the base and lower back panel with long screws and nuts.
Right Panel Attachment: Attaching the right panel to the base and lower back panel with long screws and nuts.
Upper Back Panel Attachment: Positioning the foam tape-side of the upper back panel facing the inside of the assembly and securing it to the left, center, and right-side panels with long screws and nuts.
Shelf Installation: Inserting the bottom, middle, and top shelves onto their respective brackets, ensuring the notched side faces the back.
Top Shelf Face Attachment: Securing the top shelf face to the middle and right panels with long screws and nuts.
Front Brace and Foot Pads: Attaching the front brace to the side panels with short screws and nuts, and then attaching the four foot pads to the bottom corners before standing the assembly upright.

Important Safety Warnings and Recommendations:

Read Instructions Fully: Users are advised to read all instructions entirely before attempting to assemble or use the organizer to prevent damage or injury.
Product Use: This product is exclusively for golf equipment.
Assembly Status: Do not use a partially-assembled organizer.
Commercial Use: Not intended for commercial use.
Weight Limit: Do not exceed the total weight capacity of 150 lbs.
Damage: Do not use the organizer if it is damaged.
Assembly Surface: Perform assembly on a flat, level surface.
Missing/Defective Parts: Contact Milliard Brands at info@milliardbrands.com or call 866.686.4891 if any parts are missing or defective.

The Milliard Golf Organizer is designed to be a practical and durable storage solution for golf enthusiasts, emphasizing organization and accessibility while adhering to clear safety guidelines.