EasyManuals Logo

Milltronics RH Series User Manual

Milltronics RH Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
C
HAPTER
1 - S
AFETY
7
enclosure, the machine should be put in an emergency stop condition, de-energizing
the axis servo motors and spindle motor.
Following these precautions prevents someone from becoming trapped or entangled in
the machine.
If a person should become trapped in the machine, the safest procedure is to put the
machine in emergency stop by pressing the red EMERGENCY STOP button, then
powering the machine down using the main disconnect switch on the door of the
electrical cabinet at the rear of the machine.
When the machine is put into emergency stop mode, the servo motors and the spindle
motor are de-energized. If the machine has a horizontal tool change platter and the
platter is under the spindle, emergency stop causes the platter to withdraw from
underneath the spindle.
When there is no power to the machine, the ballscrews for the X and Y axes may be
moved by hand. The Z axis remains locked to prevent the head from falling. If
compressed air is disconnected from the machine, a horizontal tool change platter may
be moved in and out by hand.
Machine Safety Labels
Please read and understand all of the safety and warning labels on the machine prior to
using the equipment. Failure to observe these labels can result in injury or death.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Milltronics RH Series and is the answer not in the manual?

Milltronics RH Series Specifications

General IconGeneral
BrandMilltronics
ModelRH Series
CategoryControl Systems
LanguageEnglish

Related product manuals