Milltronics RH Series - Page 5

I NSTRUCTION H ANDBOOK
S ERVING THE M ETAL C UTTING I NDUSTRY S INCE 1973
1400 M ILL L ANE • W ACONIA , MN 55387
T EL : 952.442.6455 • F AX : 952.442.6457
Chapter 5 - Failure Modes, Detection and Prevention................................................... 35
Minimizing Wear and Tear .........................................................................................35
Clearing Faults in Electrical Components...................................................................35
Diagnosing Mechanical Faults ...................................................................................36
Chapter 6 – Maintenance.............................................................................................. 37
Periodic Maintenance; Verification Of Safety Systems............................................... 37
Maintenance Schedule............................................................................................... 37
Always........................................................................................................................37
Daily ...........................................................................................................................37
Weekly ....................................................................................................................... 37
Monthly....................................................................................................................... 38
Annually .....................................................................................................................38
Safety Checks, to be carried out monthly and after maintenance operations.............38
Air System Maintenance ............................................................................................39
Way Lube Maintenance.............................................................................................. 40
Automatic Tool Changer (ATC) Maintenance.............................................................43
Chapter 7 – 8200 CNC Operation.................................................................................45
Milltronics 8200 CNC Front Panel .............................................................................. 45
Power ON...................................................................................................................45
Power OFF................................................................................................................. 45