Milnor 48040F7J - Fluid Containers; Components that Become Worn; Bearings and Bushings; Table 3 Fluid Containers

Pellerin Milnor Corporation 15
Table 2 Filters, Screens, and Sensitive Components (cont'd.)
Mark
Do this each
Component More Data. See also Section 3.1.2 , page 17
1 2 3 4
5 6
x
200 hours strainer for steam inlet.
(Steam is optional on
some models.)
See Figure 14, page 28
x
200 hours speed sensor photoeye.
Optional on some models.
See Figure 18, page 31
3.1.1.3 Fluid Containers
BNUUUH01.R11 0000399351 A.6 A.26 A.16 11/16/21 9:04 AM Released
Examine these items. Add fluid if necessary and keep components clean to prevent damage.
Table 3. Fluid Containers
Mark
Do this each
Component
More Data. See also Section 3.1.3 : Lubricant Identi-
fication, page 18
1 2 3 4
5 6
x
200 hours Disc brake reservoir See Figure 21, page 34. Examine the oil level and qual-
ity. Add oil Dot3 (Table 9, page 18) if necessary. If the
oil is contaminated, it is necessary to bleed the brake
system. Speak to your dealer or Milnor. This is not rou-
tine maintenance.
none
gear reducer — CO-
BUDHFA, COBUD-E,
COBUD-H
Sealed. No oil maintenance necessary.
3.1.1.4 Components that Become Worn
BNUUUH01.R12 0000399389 A.6 A.26 A.23 11/16/21 11:00 AM Released
Examine these items. Tighten or replace the item if necessary, to prevent shutdowns and un-
satisfactory performance. Speak to your dealer for replacement parts.
Table 4. Components that Become Worn
Mark
Do this each
Component
More Data
1 2
3
4
5
6
x
200 hours drive belts and pulleys See Section 3.2.1 , page 23
x
200 hours tubes and hoses (non-
hydraulic)
Examine hoses and hose connections for leaks.
x
1200 hours door bumpers Replace if damaged.
x
200 hours rubber springs See Figure 22, page 35
x
200 hours shock absorbers See Section 3.3.4 , page 34
3.1.1.5 Bearings and Bushings
BNUUUH01.R13 0000399388 A.6 A.26 11/16/21 11:04 AM Released
Unless the item is sealed, apply grease to prevent damage. See the next section for motors.
Routine Maintenance