Pellerin Milnor Corporation
Figure 3. Bearing Housing Rear
Legend
B. Detail view of the bearing housing rear
E. Apply adhesive to the bolt.
F. Add shims to a thickness of .004 inches — .005 inches. The shaft must turn in the housing. For details of the rec-
ommended procedure, refer to the document MSSM0261AE.
G. Apply adhesive to the outer circumference of the seals. Let the adhesive dry for 24 hours. Make sure that all ap-
plicable surfaces are clean and free from oil before you assemble.
J. Apply primer and adhesive to the rear bearing cup and holder housing.
K. The seal holders must be fully down before you tighten the fasteners.
M. instances 8
N. instances 4
Bearing Housing Components MWF27
3 of 4
BPWMAB03 / 2017502A
BPWMAB03 0000166675 B.2 12/11/17 3:34 PM Released
62
To Next Page
