R
Pellerin Milnor CorporationPellerin Milnor Corporation
P. O. Box 400, Kenner, LA 70063-0400
Litho in U.S.A.
4 (See
BIIFBM13.)
(See BMP130002.)
5
Section A-A: Door Installation
Section C-C: Section D-D:
Section B-B: Door Installation
1.
2.
3.
Apply a continuous bead of silicone
completely around the rubber seal, in
the area where the glass is to be
seated.
Install the gasket into the door before
installing the glass. Observe the
location of the rubber seal joint line and
adjust if necessary.
While installing the glass into the rubber
seal, ensure that no silicone is exposed
on outer surface of the rubber seal.
8
1
3
2
2
3
9,7
8
CC
D
D
Ensure that the gasket joint
is at top-dead-center.
Door Glass Installation
Door Assembly
Door Assembly:
BMP130057/2013484A
(2/3)
MWF27J8, MWF27J8
Door Assembly and Installation
77
To Next Page
