Table of Contents
PELLERIN MILNOR CORPORATION
Sections Figures, Tables, and Supplements
1.5. Formulas in Milnor
®
Washer-extractors with E-P
OneTouch
®
Controls (Document BICEUP02)
1.5.1. Hotel and Hospitality Configuration (Document BICEUP03) Table 4: Bed and Bath Linen Formulas
Table 5: Food and Beverage Service
Formulas
1.5.2. Healthcare Configuration
(Document BICEUP04) Table 6: Bed and Bath Linen Formulas
Table 7: Personal and Food/Beverage
Formulas
Chapter 2. Configuring
2.1. Configuring E-P OneTouch
®
Washer-extractor Models
(Document BICEUC01)
2.1.1. Is this switch position ON or OFF? Figure 6: Typical DIP switch on
08BT168AT
Figure 7: Typical DIP switch on
08BT168BT
2.1.2. Configuration Decisions for Machines with Controller
08BT168AT
2.1.2.1. Position 1: Use Formula Set A?
2.1.2.2. Position 2: Cold final rinse?
2.1.2.3. Positions 3 through 6: not used
2.1.2.4. Position 7: Normal operation?
2.1.2.5. Position 8: Normal operation?
2.1.3. Configuration Decisions for Machines with Controller
08BT168BT
Table 8: Controller 08BT168BT:
Summary of Configuration Decisions
2.1.3.1. Position 1: Configure for hospitality?
2.1.3.2. Position 2: Use Bed and Bath Linen formulas?
2.1.3.3. Position 3: Use cold water for the final rinse?
2.1.3.4. Positions 4 and 5: Select desired hot bath temperature Table 9: Quick Reference for Hot Bath
Temperature
2.1.3.5. Position 6: Use 140°F (60°C) for split bath
temperature?
2.1.3.6. Position 7: Run bath timer while heating?
2.1.3.7. Position 8: Set machine to normal operating mode?
Chapter 3. Operating
3.1. Determining Load Size (Document BIWUUO01)
3.2. Controls on E-P OneTouch
®
Model Washer-extractors
(Document BICEUF01)
Figure 8: E-P OneTouch
®
Controls
3.2.1. Control Functions During Normal Operation
3.2.1.1. Formula Selection Buttons
3.2.1.2. Terminate Button