Milwaukee FORCE LOGIC M18 - How to Knockout; Measure panel and mark box; Drill pilot holes; Set up tool and punches;dies

How to Knockout
1. Measure panel and mark box
2. Drill pilot holes
3. Set up tool and punches/dies
4. Tighten to panel, and align
with pre-drawn crosshairs
5. Pump or power knockout tool
6. Unthread and remove material
Milwaukee
®
Improves Every Step
1. Measure panel and mark box
Crosshairs match dies. Milwaukee
®
tapes and Inkzall
®
.
2. Drill pilot holes
Milwaukee
®
Step Drill Bit for cordless drill.
3. Set up tool and punches/dies
Milwaukee
®
’s Quick Connect Alignment System delivers tool-free set-up.
4. Tighten to panel, and align
with pre-drawn crosshairs
EXACT
™
crosshair alignment, and easy thread-on draw stud.
5. Pump or power knockout tool
M18
™
powered, or hand ratchet with improved leverage.
6. Unthread and remove material
Slug removal ports and reliable splitting geometry
for best in class reset times.
2