5
(4) Wiper blade ("Cleaning around the wiper” Chapter 4 of the Operation Manual)
Ink, dust, and paper dust gather on the wiper blade. Check the status of the wiper blade, and if it is dirty, clean
it.
1
Move the carriage and open the right maintenance
cover.
• Refer to the Step 1 to 5 of Chapter 4 “Cleaning
around the wiper” of the user’s manual to perform
the operation.
2
Clean the wiper blade.
• Wipe off the ink of the wiper blade with clean stick or
waste cloth dipped in cleaning solution for
maintenance.
(5) Media press (“Cleaning the Media Press” Chapter 4 of the Operation Manual)
When the cut dust of the media and other dusts accumulate between the media holder and the platen, it could
cause the risks that the transfer of the media could not be performed properly or such dusts stick to the noz-
zles and this could interfere the proper printings. You are recommended to clean it frequently.
(6) Media sensor ("Cleaning the Media Sensor" Chapter 4 of the Operation Manual)
The media sensors are located on the platen (for two positions) in the backside and the bottom surface of the
head.
If the dusts and ink accumulate on the sensor, it could cause false detection of the media or the register mark.
Wipe off the sensors with soft cloth or clean sticks.
• For the cleaning of the media sensors, never use the solvent.
• When the sensor is heavily stained, wipe off with a cloth soaked in the waterdiluted neutral
detergent.
To Next Page
Loading...
