Need help?Do you have a question about the MIMAKI TS330-1600 and is the answer not in the manual?
General| Print Width | 1600 mm |
|---|---|
| Interface | USB 2.0, Ethernet |
| Power Supply | AC 100-240V, 50/60Hz |
| Printer Type | Inkjet Printer |
| Maximum Print Width | 1610 mm |
| Print Resolution | 1200 x 1200 dpi |
| Max Media Width | 1610 mm |
| Media Width | 1, 620 mm (8.3" to 63.8") |
| Media Thickness | Up to 1 mm (0.04") |
| Ink Type | Mimaki SS21 |
| Ink Colors | Cyan, Magenta, Yellow, Black, Light Cyan, Light Magenta |
| Ink Colors (Alt) | Bl, M, Y, K, Lbl, Lm |
| Connectivity | Ethernet |
| Operational Environment | 20-30 °C, 35-65% RH |
Describes the names and functions of various parts of the machine, including front and rear views.
Provides step-by-step instructions for connecting the power cable to the machine and power outlet.
Explains how to connect a PC to the machine using LAN or USB cables for data transfer.
Details the procedures for replacing ink when the ink levels are low or the ink has run out.
Outlines the sequence of steps required to start and perform printing operations on the machine.
Explains how to adjust the gap between the print head and the media for optimal printing quality.
Guides on adjusting pinch roller positions to suit media width for proper media feeding.
Provides instructions and precautions for loading various types of media, including roll and leaf media.
Explains how to set the heater temperature to suit different media types for optimal printing.
Describes how to print test patterns to confirm ink ejection and perform head cleaning if needed.
Outlines available head cleaning methods to resolve ejection failures like nozzle clogging.
Explains how to correct media feed amount to prevent image defects like streaks.
Details how to adjust drop positions to correct defects caused by media and print head height changes.
Guides on preparing image data using RasterLink software for printing.
Covers changing the origin, starting, pausing, and stopping the printing process.
Explains the process of cutting media, including horizontal and V-shaped cuts.
Outlines the overall process for performing cutting operations on the machine.
Details how to install cutting tools like cutters and pens into the machine.
Explains how to set cutting speed and pressure to match media types and tools.
Describes how to perform test cuts to confirm tool conditions and adjust settings.
Outlines the overall workflow for cutting data that includes register marks for accurate alignment.
Explains how to create register marks, including types, size, and color recommendations.
Details how to set conditions for detecting printed register marks on the media.
Guides on detecting the origin position of register marks for accurate cutting alignment.
Outlines the process for performing ID cuts, which use unique identifiers for cutting.
Introduces the XY Slitter component and its parts, including X Cutter, XY carriage, and clamps.
Explains how to enable and perform slitting operations concurrently with printing.
Details the procedure for slitting the print media after the printing process is completed.
Provides general troubleshooting steps for common issues like power, printing, and media problems.
Lists common error messages, their causes, and corrective actions.
To Next Page
