MIMAKI TS330-1600 - DAS (Automatic Correction Function) Sensor Cleaning

Chapter 7 Maintenance
186
• Insert the cleaning stick as far as the line shown in the illustration.
5
Once cleaning is complete, close the cover, then press the [ENTER] key.
DAS (Automatic Correction Function) Sensor Cleaning
The DAS sensor is located on the carriage underside. If dust or debris accumulates on the sensor, DAS
( P. 160) may not function.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Carriage Out] > [Move To Maint. Space], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance cover on the left side.
4
Clean the DAS sensor.
• Wipe clean using cotton swabs or a soft cloth.
• For heavy soiling, wipe using a soft cloth soaked in diluted neutral detergent and
thoroughly wrung out.
5
Once cleaning is complete, close the cover, then press the [ENTER] key.