MIMAKI TS330-1600 - Setting Mark Detection Conditions

Chapter 4 Cutting Data with Register Marks
117
4.3 Setting Mark Detection Conditions
Set the conditions of the printed register marks.
1
On the LOCAL mode screen, select [MENU] > [Cutting], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [Mark Detect], then press the [ENTER] key.
• The Mark Detect menu is displayed.
• The Mark Detect menu can also be displayed as follows:
(1) On the LOCAL mode screen, select [TEST CUT].
(2) Select [TP Detect Setup], then press the [ENTER] key.
3
Select and set the items.
• "Cutting Menu"(P. 174)
4