MIMAKI TS330-1600 - Preparing RIP data

Chapter 2 Printing
86
2.11 Preparing RIP data
The explanation here applies to MIMAKI RIP software (RasterLink).
• If using TxLink, refer to the TxLink operating manual.
• Prepare suitable image data for printing.
1
Launch RasterLink.
• Click the icon on the PC desktop.
2
Select the image data to print.
(1) Select [File] > [Open].
(2) Select the desired image data, then click [Open].
• If multiple printers are registered, select 330 series in "Printer Name".
3
Select the image data imported.
• The image data is added in the tab for 330 series selected in "Printer Name".