MIMAKI TS330-1600 - Enable the XY Slitter; Positioning Printed Media; Detecting Slitting Marks

Chapter 5 Using the XY Slitter
146
2
Select the slitting method for the Y (scan) direction.
RL_XY Slitter_Y Slit method
• "None" is used when slitting only in the X (scan) direction.
3
Select [Slit Afterwards].
4
Click [Print X-Cutter Reference line].
• Guide (slit) line printing starts.
Enable the XY Slitter.
1
On the LOCAL mode screen, select [MENU] > [Function Setting], then press the [ENTER] key.
• The Function Setting menu is displayed.
2
Select [Finisher] > [XY Slitter], then press the [ENTER] key.
○ None
● XY slitter
○ Unpublished
Positioning printed media
1
Position the printed media in the feeding unit.
• "Loading the media"(P. 130)
Detecting slitting marks
1
On the LOCAL mode screen, select [MENU] > [Function Setting] > [XY Slitter] > [Slit Position
Detection].
XY slitter
Slit Position Adjustment
Slit Position Detection
Slitting Feed
>
>
>