MIMAKI TS330-1600 - Chapter 3 Cutting

Chapter 3 Cutting
This chapter
Describes cutting procedures and setting methods (CJV only).
Cutting Process ...............................................94
Installing Cutting Tools ....................................96
Using the Cutter ......................................... 96
Using a Pen.............................................. 101
Setting the Cutting Conditions.......................105
Test Cutting ....................................................106
Cutting the Cutting Data .................................107
Changing the Origin ...................................107
Starting Cutting ..........................................107
Stopping Cutting (Data Clear)....................108
Retracting the Cutter Unit ..........................108