9
(2) Replacing the mist filter
Replace it once in a week or two weeks.
1
Pull out the mist filter ASSY located at the rear surface of the main body.
• There are 6 mist filter ASSY at the rear surface of the main body (parts indicated with circles in the figure).
• Put your finger on the hole of the bottom surface, and pull out the mist filter ASSY forward.
2
Removed the used filter.
(1) Slide the filter holder a little, and remove it.
(2) Removed the used filter.
3
Attach new mist filter (SPA-0190) and the filter
holder.
4
Attach the mist filter ASSY to the original position.
• Ink at printing adheres to the mist filter ASSY. When
replacing the filter, it is recommended to perform the
work with a sheet of paper placed.
To Next Page
Loading...
