Need help?Do you have a question about the Minarik DLC600 and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Input Voltage | 24 VDC |
| Communication Interface | RS-232, RS-485 |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Enclosure Rating | NEMA 4X |
Important safety tips and warnings to be read before performing procedures.
Explains how the DLC600 regulates motor speed via frequency comparison and feedback.
Lists electrical, environmental, and performance specifications for the DLC600.
Provides detailed measurements and diagrams of the DLC600 unit.
Guidelines for securely mounting the DLC600 unit, avoiding hazards.
Steps for cutting a panel opening and installing the DLC600 unit.
Details on connecting line voltage, output, feedback, inhibit, and frequency terminals.
Recommendations for using shielded cables to prevent electrical noise interference.
Summarizes connections for Line Voltage, Output, Feedback, Inhibit, and Frequency terminals.
Criteria and calculations for selecting appropriate feedback devices based on RPM and PPR.
How to set the voltage input using SW501.
Setting the voltage for external encoders using SW502 DIP switch 1.
Configuring feedback device type via SW502 DIP switches 2 & 3.
Selecting internal or external reference signals using SW502 DIP switches 4 & 5.
Explains how to adjust trim pots for optimal drive response and speed regulation.
Steps to set the MIN and MAX trim pots for motor speed control.
Calculate parameters like SSF, Load Response, Gate Time, and Decimal Point.
Access programming mode and input calculated parameters and speed settings.
Practical examples of calculating and programming parameters.
Explains using the DLC600 to follow an external frequency for synchronized operation.
Step-by-step guide for setting up a leader-follower system with a leader encoder.
Instructions for configuring two DLC600 units for leader-follower operation.
Common causes and solutions when the motor fails to start.
Diagnosing and resolving problems with the motor not achieving or maintaining set speed.
Troubleshooting fixed speed differences between set and actual motor speeds.
Details on Minarik Drives's product warranty, disclaimer, and limitations of liability.
To Next Page