Part I Service Scenarios
Installation 25
RFID
c Scan the following barcode to disable the suffix function:
Barcode
RFID
1.2.6 Software Setup
1.2.6.1 Running the System
After powering up the system, the standby indicator on the control panel of the main unit is off, the
battery indicator is displayed based on the battery status, and the disk indicator is displayed based on the
disk access status. After you press the Power key during the power-up process, the battery level screen
will display the equipment model and battery level, and turn off after displaying the information for 6s.
The Part I Service Scenarios: 3.1.3Get Entire Device Started
screen will appear during the power-up
process.
1.2.6.2 Accessing Doppler
After power-up, the ultrasound system experiences a series of initialization actions (for about 1 minute)
and directly enters the Doppler screen.
To Next Page
Loading...
Need help?
General
