Minebea CSD-891B - Page 137

123
D F−31 Setting the target of comparator
Initial value＝00000 0＝Gross weight
1＝Net weight
10
0
digit：Comparator S0
10
1
digit：Comparator S1
10
2
digit：Comparator S2
10
3
digit：Comparator S3
10
4
digit：Comparator S4
※The comparator S0 is effective in the setting 00007 by F−33.
D F−32 Setting the direction of comparator
Initial value＝00000 0＝or more
1＝or less
10
0
digit：Comparator S0
10
1
digit：Comparator S1
10
2
digit：Comparator S2
10
3
digit：Comparator S3
10
4
digit：Comparator S4
※The comparator S0 is effective in the setting 00007 by F−33.
D F−33 Setting applicable condition for the comparator S0
Initial value＝00000 00000＝ON when load display value≧the maximum display value
00001＝ON when both S1 and S2 open collector output are OFF.
00002＝ON when both S1 and S3 open collector output are OFF.
00003＝ON when both S1 and S4 open collector output are OFF.
00004＝ON when both S2 and S3 open collector output are OFF.
00005＝ON when both S2 and S4 open collector output are OFF.
00006＝ON when both S3 and S4 open collector output are OFF.
00007＝Operation whichever “open collector ON over the set
value” or “open collector ON less than the set value”
00008＝Interlocked with HOLD LED
00009＝Interlocked with A/Z LED
00010＝Interlocked with LOCK LED
00011=ON when the detection of stability
D F−34 Setting the condition of Hysteresis operation for comparator
Initial value＝00000 00000＝ON delay
00001＝OFF delay
D F−35 Hysteresis data width OFF
Initial value＝00000 00000＝Hysteresis data width OFF
Setting rage：00000〜00099
Unit：1D
Data width of 99D at the setting of “00099”.