Minebea CSD-891B - Page 138

124
D F−36 Setting Hysteresis time width for comparator
Initial value＝00000 00000＝Hysteresis time width OFF
Setting rage：00000〜00099
Unit：0.01 s
Data width of 9.99 s at the setting of “00999”
D F−40 Setting the target of BCD output(Effective when the option is installed.)
Initial value＝00000 00000＝Gross weight
00001＝Net weight
00002＝Changeover of external input
D F−41 Setting the logic of BCD output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−42 Setting the polarity of BCD output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−43 Setting the logic of BCD flag output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−44 Setting the logic of BCD P.C. output (Effective when the option is installed.)
Initial value＝00000 00000＝Negative logic
00001＝Positive logic
D F−45 Setting the BCD P.C. width(Effective when the option is installed.)
Initial value＝00001 00000＝125 ms
00001＝25 ms
00002＝10 ms
00003＝
5ms
00004＝2.5 ms
D F−46 Setting the BCD output rate(Effective when the option is installed.)
initial value＝00001 00000＝4 times/s
00001＝20 times/s
00002＝50 times/s
00003＝100 times/s
00004＝200 times/s
D F−50 Setting the operation mode of RS−232C
(Effective when the option is installed.)
Initial value＝00001 00000＝Stream mode
00001＝Command mode