125
D F−51 Setting the target of output at the time of stream mode of RS−232C
(Effective when the option is installed.)
Initial value＝00000 00000＝Gross weight
00001＝Net weight
00002＝Display interlock
※In the Command mode, the data are transferred from the host by the command.
In the Stream mode, the latest data will be output continuously.
D F−52 Setting the baud rate of RS−232C/422/485
(Effective when the option is installed.)
Initial value＝00003 00000＝1 200 bps
00001＝2 400 bps
00002＝4 800 bps
00003＝9 600 bps
00004＝19 200 bps
00005＝38 400 bps
D F−53 Setting the data bit length and parity of RS−232C/422/485
(Effective when the option is installed.)
Initial value＝00021 10
0
digit：Setting data bit length
0＝8 bit
1＝7 bit
10
1
digit：Setting parity
0＝No parity
1＝Even number parity
2＝Odd number parity
D F−54 Setting the stop bit of RS−232C/422/485
(Effective when the option is installed.)
Initial value＝00000 00000：1 bit
00001：2 bits
D F−55 Setting the terminator of RS−232C/422/485
(Effective when the option is installed.)
Initial value＝00001 00000：CR
00001：CR+LF
D F−56 Setting the decimal point of sending code of RS−232C/422/485
(Effective when the option is installed.)
Initial value＝00000 00000：No decimal point
00001：Yes of Decimal point
D F−57 Setting the ID number of RS−422/485(Effective when the option is installed.)
Initial value＝00000 Setting range：00000〜00031
D F−58 Changing RS−422/485(Effective when the option is installed.)
Initial value＝00000 00000：RS−422
00001：RS−485
To Next Page
Loading...
