Minebea CSD-891B - Page 73

59
Procedures
Transmit the change command of the maximum
display value from the host, and set the
maximum display value. The setting range of the
maximum display value is (The minimum digits
×100)〜99 999. To use the performance
effectively, set the value in the following ranges.
If you set the value exceeding the following
ranges, there may cause the unstable displays,
etc.,
The maximum display value
2 4 6 8 10 12 14
@ 0 0 1 1 2 0 0 0 Termi
ID No.
Command Host→CSD−891B
Return CSD−891B→Host
Nl
ii
-nator
3
The setting range of the
maximum display value
100〜10 000
200〜20 000
500〜50 000
1 000〜99 990
The minimum
digits
1
2
5
10
The display in the load display section displays
“−RS−” and “Z MV” alternately.
 Don’t attach the decimal point to the
setting value in the command data.
 The setting value in the command data is
put from the right, and an unnecessary
space is given as space.
2 4 6 8 10 12 14
@ 0 0 1 1 2 0 0 0 Termi
ID No.
・Normal termination
The maximum display value
2 4 6 8 10 12 14
@ 0 0 1 1 E R - 2 Termi
ID No.
・Set in error
-nator
-nator