8 Version 1.0
3 more times and turn off (if motion is detected
immediately). The device is now in motion
detection mode.
3. If you choose to use battery power, point the
remote at the device and press the power
button on the remote (see page 4). The Green
light will blink once and then the Red light will
blink 3 more times and turn off (if motion is
detected immediately). The device is now in
motion detection mode.
NOTE: If the light doesn’t come on, try many different
angles when pressing the power button and pointing it
at the front/top of the unit. Do not hold down the power
button. Press and release the button only.
4. To put the device into standby mode, stop
motion recording by pressing the motion
detection button one time (see page 4). The
Green light will come on, and the device will be
in standby mode.
To Next Page
Loading...
