– In resting position: turn the switch
downward, arrow 3. The switch auto-
matically returns to its idle position
when released.
– In intermittent operation: turn the
switch further, arrow 2. The switch au-
tomatically returns to its interval posi-
tion when released.
The function is deactivated if the washer
fluid reservoir fill level is low.
Fold-out position of the wipers
Principle
The fold-out position enables the wipers to
be folded out from the windshield.
General information
Helpful when changing the wiper blades or
under frosty conditions, for instance.
Safety information
Warning
If the wipers start moving in the folded
away state, body parts can be jammed or
damage may occur to parts of the vehicle.
There is a risk of injury or risk of damage
to property. Make sure that the vehicle
is switched off when the wipers are in
the folded-away state and the wipers are
folded in when switching on.
NOTICE
If the wipers are frozen to the windshield,
the wiper blades can be torn off and the
wiper motor can overheat when switching
on. There is a risk of damage to property.
Defrost the windshield prior to switching
the wipers on.
Folding out the wipers
1. Switch the ignition on and off again.
2. Press and hold the wiper lever down un-
til the wipers stop in a nearly vertical
position.
3. Fold the wipers all the way out from the
windshield.
Folding in the wipers
After the wipers are folded back down, the
window wiper system must be reactivated.
1. Fold the wipers back in onto the wind-
shield.
2. Turn on the ignition.
3. Push wiper lever down. Wipers return
to their resting position and are ready
again for operation.
Seite 109
Driving CONTROLS
109
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
