Cleaning the windshield
Pull the lever.
The washer fluid is sprayed on the wind-
shield, and the wipers are turned on briefly.
Windshield washer nozzles
The washer jets are automatically heated
whenever the ignition is switched on.
Rear wiper
Switching on the rear wiper
Turn the outer switch upward.
– Resting position of the wiper, posi-
tion 0.
– Intermittent operation, arrow 1. When
reverse gear is engaged, the system
switches to continuous operation.
Clean the rear window
Turn the outer switch in the desired direc-
tion.
– In resting position: turn the switch
downward, arrow 3. The switch auto-
matically returns to its idle position
when released.
– In intermittent operation: turn the
switch further, arrow 2. The switch au-
tomatically returns to its interval posi-
tion when released.
The function is deactivated if the washer
fluid reservoir fill level is low.
Fold-out position of the wipers
Principle
The fold-out position enables the wipers to
be folded out from the windshield.
General information
Helpful when changing the wiper blades or
under frosty conditions, for instance.
Safety information
Warning
If the wipers start moving in the folded
away state, body parts can be jammed or
damage may occur to parts of the vehicle.
There is a risk of injury or risk of damage
to property. Make sure that the vehicle
is switched off when the wipers are in
the folded-away state and the wipers are
folded in when switching on.
NOTICE
If the wipers are frozen to the windshield,
the wiper blades can be torn off and the
wiper motor can overheat when switching
on. There is a risk of damage to property.
Defrost the windshield prior to switching
the wipers on.
Seite 112
CONTROLS Driving
112
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
