Aquaplaning
On wet or slushy roads, a wedge of water
can form between the tires and road sur-
face.
This phenomenon is referred to as aqua-
planing. It is characterized by a partial or
complete loss of contact between the tires
and the road surface, ultimately undermin-
ing your ability to steer and brake the vehi-
cle.
Driving through water
General information
When driving through water, follow the fol-
lowing:
– Deactivate Auto Start/Stop function.
– Drive through calm water only.
– Drive through water only if it is
not deeper than maximum 9.8 in-
ches/25 cm.
– Drive through water at a maximum of
walking speed, up to 3 mph/5 km/h.
Safety information
NOTICE
When driving too quickly through deep
water, the water can penetrate the engine
compartment, the electrical system, or the
transmission. There is a risk of damage to
property. When driving through water, do
not exceed the maximum indicated water
level and the maximum speed for driving
through water.
Braking safely
General information
The vehicle is equipped with an Antilock
Braking System as a standard feature.
Perform emergency braking in situations
that require such. To achieve the best possi-
ble brake boosting, do not reduce the pres-
sure on the brake pedal during full braking.
Steering is still responsive. You can still
avoid any obstacles with a minimum of
steering movement.
The pulsation of the brake pedal and sounds
from the hydraulic circuits indicate that the
Antilock Braking System is in its active
mode.
Objects in the travel path of the pedals
Warning
Objects in the driver's footwell can limit
the pedal travel or block a depressed pedal.
There is a risk of accident. Stow objects in
the vehicle such that they are secured and
cannot enter into the driver's footwell. Use
floor mats that are suitable for the vehicle
and can be safely attached to the floor.
Do not use loose floor mats and do not
layer several floor mats. Make sure that
there is sufficient clearance for the pedals.
Ensure that the floor mats are securely fas-
tened again after they were removed, for
instance for cleaning.
Driving in wet conditions
In case of wet roads, exposure to road salt
or in heavy rain, gently depress the brake
pedal every few kilometers.
Ensure that this action does not endanger
other road users.
The heat generated during braking dries
brake disks and brake pads and protects
them against corrosion.
In this way the brake force will be available
when you need it.
Seite 236
DRIVING TIPS Things to remember when driving
236
Online Edition for Part no. 01405A7DAD4 - II/23
To Next Page
Loading...
Need help?
General
