▷ Use of the Mobility System may be ineffec‐
tive if tire damage is greater than approx.
1/8 in/4 mm in size.
▷ Contact a dealer’s service center or another
qualified service center or repair shop if the
tire cannot be made drivable.
▷ If possible, do not remove foreign bodies
that have penetrated the tire.
▷ Pull the speed limit sticker off the sealant
bottle and apply it to the steering wheel.
Sealant and compressor
1 Sealant bottle and speed limit sticker
2 Filling hose
Note the use-by date on the sealant bottle.
3 Holder for the sealant bottle
4 Compressor
5 Connector and cable for the lighter socket/
socket in passenger compartment 110.
6 Connection hose for connecting the com‐
pressor and sealant bottle or the compres‐
sor and wheel
7 On/off switch
8 Pressure gauge for displaying the tire infla‐
tion pressure
9 Release button for reducing the tire infla‐
tion pressure
The connector, cable, and connecting hose are
stowed in the compressor housing.
Using the Mobility System
To repair a flat tire with the Mobility System,
proceed as follows:
▷ Filling the tire with sealant
▷ Distributing the sealant
▷ Correcting the tire inflation pressure
Filling the tire with sealant
1.
Shake the sealant bottle.
2. Pull the connection hose 6 fully out of the
compressor housing and screw it onto the
sealant bottle connection. Ensure that the
connection hose is not kinked.
3. Insert the sealant bottle into the compres‐
sor housing in a vertical position.
4. Unscrew the dust cap off of the valve of the
not working wheel and screw the filling
hose 2 of the sealant bottle onto the valve.
5. Ensure that the compressor is switched off.
6. Insert connector 5 into the lighter socket/
socket in the passenger compartment, refer
to page 110.
7. When the engine is running:
Seite 227
Wheels and tires
MOBILITY
227
Online Edition for Part no. 01 40 2 964 459 - VI/15
To Next Page
Loading...
