AMP OPERATION E
13
WARNING !
AMP is not designed to operate with
loudspeakers with an impedance
lower than 4 Ω.
Should you use such loudspeakers,
the reliability of AMP will be
compromised.
Should AMP enter protection mode
(random interruption of sound) it is
essential that the volume be
decreased until such interruptions
cease.
If you continue to operate AMP whilst
it is in protection mode, it will lead to
the destruction of the unit.
AMP is not designed to perform as a
professional device and should never
be used in such applications
Failure to follow the above warnings
may invalidate the products
guarantee.
WARNING !
When AMP is set in AVP mode, AMP
is put automatically to maximum
volume to enable the control of the full
Audio/Video system volume through
AVP.
It is important to put AMP in AVP
mode ONLY if you possess and
have connected the AVP processor.
To safeguard against the damage that
WILL be caused through misuse of the
AVP mode, it is necessary to confirm
your choice of the AVP mode by a
second pressing of the AVP key.
Should you accidentally press on
the AVP key of the remote control
handset, a single press of any
system key ( CD or FM ) will return
AMP to normal operation.
To Next Page
Loading...