MINN KOTA 1810244 - User Manual

QUICK RELEE DISCONNE PLUG
1810244
1. Completely disconnect the Talon from battery power.
2. Remove the (4) #8-16 x 1.5” plastite screws (item b) from the shallow cowling half on the right side. Leave the (2) lower
#8-32 x 1” screws in place (image 1).
3. Remove the (2) #8-32 x 5/8” screws from the left motor cover housing to completely remove the housing (image 2).
4. There are 5 electrical leads total. DO NOT CUT THE BLACK OR RED MOTOR LEADS. Being careful not to cut the wire
jackets, use a utility knife to carefully scribe a vertical cut only on the heat-shrink of the white, black, and green wire termi-
nations of the power cable at the base of the control board. Use a needle nose pliers to peel away the cut heat-shrink.
5. Using a needle nose pliers, carefully pull up to disconnect the white, black, and green wires of the power cable from the
control board shown in image 3.
NOTE: Remove the fuse and fuse cap from the old power cable and assemble it onto the new quick release disconnect
plug.
Parts Included:
Description Part Number Qty.
Talon Cable Connector Assembly 2377510 1
Shrink Tube - 3/8” ID x 1.0” 2305404 3
minnkotamotors.com
©2015 Johnson Outdoors Marine Electronics, Inc.
Remove these four screws
Left Side
Right Side
Right Side
Image 1
Image 2

Summary

Quick Release Disconnect Plug Installation

Disassembly and Wire Preparation

Disconnect power, remove motor cowling, and prepare wires by cutting heat shrink for disconnection.

Reassembly and Cable Connection

Route new cable, secure strain relief, connect terminals, seal with heat shrink, and reassemble motor cover.

MINN KOTA 1810244 Specifications

General

Thrust	40 lbs
Voltage	12V
Motor Type	Electric
Shaft Length	36 inches
Speed Settings	5 Forward / 3 Reverse
Battery Requirement	12V deep cycle marine battery