D-117
4-4. REMOUNTING EPROM
NOTE
If the PW Board has replaced, be sure to remount EPROM from the old to new PW Board.
If the PW Board has been replaced and EPROM has not been remounted, be sure to
replace the PC Drum with a new one. EPROM contains no data in this case, so make
entries again of numeric values given on the Adjust Label.
(1) Remounting EPROM on the Master Board
1. Remove the Master Board.
2. Remove EPROM (IC101) from the new Master Board.
3. Remove EPROM (IC101) from old Master Board and remount it onto the new Master
Board.
4002D529AA
NOTE
Note the alignment notch (A) on EPROM (IC101) when
mounting the IC.
4002D530AA
A
To Next Page
Loading...
