S-41
6. ADJUST MODE
• Used at the factory for making adjustments.
NOTE:
• Use only when the RAM Board has been replaced. If any of the adjustment values has
been changed, be sure to enter the value in the label affixed to the copier.
6-1. Adjust Mode Menu Screen
6-2. Adjust Mode Setting Procedure
<Procedure>
1. Show the Tech. Rep. mode menu screen.
2. Press the following keys in this order:
Stop → Start
3. Select the desired function.
<Exiting the Mode>
• Press the Panel Reset key.
4003P604CA
To Next Page
Loading...
