T- 2 5
PF-115 Paper Take-Up Misfeed Troubleshooting Procedures
• Paper is not taken up at all.
• Paper is stopped at the Vertical Transport Rollers.
Step Check Result Action
1 Paper meets product specifications. NO Change paper.
2 Paper is curled, wavy, or damp. YES Change paper.
Instruct user in correct
paper storage.
3 Paper Lifting Plate is dirty or deformed. YES Clean or change.
4 Paper Separator Pad is dirty with paper dust,
deformed, or worn.
YES Clean or change.
5 Paper take-up guide plate is dirty or deformed. YES Clean or change.
6 Paper Take-Up Roll and Separator Roll are
dirty with paper dust, deformed, or worn.
YES Clean or change.
7
3
rd
Drawer Paper Take-Up Motor turns when
the Start key is pressed with the 3
rd
Drawer
selected.
NO Correct drive coupling.
Change motor or Control
Board.
Change Master Board.
Step Check Result Action
1 Vertical Transport Rollers are dirty with paper
dust, deformed, or worn.
YES Clean or change.
2 Paper take-up guide plate or vertical transport
guide plate is dirty or deformed.
YES Clean, correct, or change.
3 Vertical Transport Motor turns when the Start
key is pressed with the cabinet selected.
NO Correct drive coupling.
Change motor or Control
Board.
Change Master Board.
4
I/O check for 3
rd
Drawer Paper Take-Up Sensor
operation when the 3
rd
Drawer is used: the
voltage across PJ9A-11 on Control Board and
GND is DC5V when the sensor is unblocked
and DC0V when the sensor is blocked.
YES Change Control Board or
Master Board.
NO Correct actuator.
Change sensor.
5 I/O check for Paper Leading Edge Sensor 3
operation when the 3
rd
Drawer is used: the
voltage across PJ9A-5 on Control Board and
GND is DC5V when the sensor is unblocked
and DC0V when the sensor is blocked.
YES Change Control Board or
Master Board.
NO Correct actuator.
Change sensor.
To Next Page
Loading...
