D-10
(3) Removal of the Main Hopper Unit
1. Swing down the Front Door and slide out the Developer Unit.
2. Remove the Right Cover.
8. Swing down the Transport Section Release Lever.
9. Holding up the Suction Unit, remove the compres-
sion coil.
4002D031AD
10. Remove the Suction Unit by sliding it to the right.
1136D101AA
NOTE
When reinstalling the Suction Unit, make sure that two
positioning pins on the copier fit into the positioning
holes in the Suction Unit.
1134D028AA
3. Unplug two connectors, remove four screws and
remove the Main Hopper Unit.
4002D032AD
To Next Page
Loading...
