Minolta DYNAX 5 - Page 121

(2163)A 51
@ Fig. 1 @ Fig. 2
1. Install BACK COVER SEPARATION PLATE SP Stick LIGHT SHIELD TAPE to the designated
to BACK COVER SEPARATION PLATE. position of BACK COVER ASSY.
2% Hook a tip of BACK COVER SEPARATION
PLATE SP to the groove of BACK COVER
SEPARATION PLATE, then fit the other tip aad
instal BACK COVER SEPARATION PLATE to
BACK COVER ASSY. BACK COVER ASSY
BACK COVER PS
SEPARATION PLATE iss "
Tp @ | Gaceee
wih
Groove . o cK rE Vt 3 7 I
BACK COVER aoa
SEPARATION PLATE ‘SP = : Sy
—s Lf
ASSY :
@ Fig. 8 @ Fig. 4
1. Insert the arm-a of PRESSURE PLATE ASSY in 1. Apply G-45 and G-35 in the designated position
arrow direction fitting to the post of BACK of BOTTOM COVER ASSY and PANORAMA
COVER ASSY, CHARGE OVER LEVER.
2, Insert the arm-b of PRESSURE PLATE ASSY in 2. Install the longer post of PANORAMA CHARGE
the same way. OVER LEVER fiiting the standard position of
$3. Bend the arm-c of PRESSURE PLATE ASSY to BOTTOM COVEE ASSY.
fit to the post of BACK COVER ASSY. 3. Hook the tab of PANORAMA CHARGE OVER
LEVER SP to the post of PANORAMA CHARGE
OVER LEVER.
Post (ander the metal plate)
@ Fig. 5
Insert BATTERY COVER HINGE AXIS to the
groove of BOTTOM COVER ASSY os illustrated. PANORAMA CHARGE
sainDuWday
|