Turn the camera on, then press
the date button to choose the
data imprinting format.
• When the date-time display is blinking or -- -- -- is displayed on the data
panel, date/time information will not be imprinted. The date/time
information needs to be entered (p.51).
• The cycle will be only “no imprinting” and “set mode” when the data and
time are not entered.
The display will change as follows :
FOR OWNERS OF THE QUARTZ-DATE MODEL
1.Turn the camera on. Press the date
button until “SEt” appears on the
data panel.
2.Press the select button until the
item to be adjusted blinks.
• The next item will blink each time the select
button is pressed.
stops
blinking
SETTING THE DATE OR TIME
The data and time must be reset each time the battery is replaced.
YEAR
MONTH
HOURS
MINUTES
51
DATE
Date imprinting
Day/Time Imprinting
(No imprinting)
Set mode
50
To Next Page
Loading...
