② Vertical merging method (Fig. 19)
When taking pictures of the edges of a subject or
vertical objects such as buildings or towers, and
the subject is jutting out vertically from the as
shown in Fig. 19-1, turn the lens focus ring so that
they are together in the as shown in Fig. 19-2.
10. Unloading the Film
(Fig. 20)
When the loaded film reaches the end, it is
automatically rewound.
The rewind will automatically stop when it is
complete and the film counter will show “0”
blinking. Open the back cover and remove the
film.
★ Do not remove film in any location that is
exposed to direct sunlight.
★ We recommend that film be developed as soon
as possible after it has been exposed.
★ Film can be rewound with the tip out.
Immediately before the film has completed
rewind and after the “1” lights in the film counter,
the film will stop for about one second with “--”
displayed (Fig. 21). If you open the back cover
now, the film tip will remain out. Make sure that
you don't make a mistake and reuse that film
again.
★ Film rewinds can be paused temporarily. If the
main switch lever is turned while the rewind is in
operation, the power will go off and the rewind
will stop. Turn the power on again. This is an
excellent function to use when taking pictures at
places like wedding ceremonies where you
don't want the rewind noise heard (you want to
pause the rewind).
To Next Page
Loading...
