2) Automatic light adjust photography/manual
exposures photography
(1) Select either AUTO-1 or AUTO-2 the same as
with focus priority AE photography (Fig. 35).
(2) Look at the indications inside the finder and
select the correct shutter speed.
★ The camera cannot be synchronized to a speed
higher than 1/125 second.
(3) Check the flash indicator to make sure the
battery is fully charged, focus the camera and
take pictures.
★ To select a focus other than AUTO-1 or AUTO-2,
set the rotary switch on the flash to "FULL".
Decide what the correct focus value is by using
the formula below.
The formula to give the correct aperture value
Guide Numbers (GN)
Correct aperture value (F) =
Focused Distance
★ For guide numbers according to film sensitivity,
see the flash instructions.
Using the Konica HX-14 (purchased
separately)
The HX-14 is operated in basically the same way
as the HX-18W.
★ Automatic light adjustment can be used in the
position A and full-light emission flash can be
used in the P. FULL position. However, the
focus in automatic light adjustment photography
(position A on the flash) is F4 with ISO100.
★ The full-charge indicator (125
) does not light
inside the finder when in position A.
To Next Page
Loading...
