Minolta MN4KP1 - Page 17

ϯhƐŝŶŐdŚĞĂŵĐŽƌĚĞƌ

3.4.8 Auto Screensaver
This function sets the duration of time in which the camcorder will wait with
no user input before automatically turning the LCD screen off.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button twice to enter Options Setup Mode.
4. Select ‘Auto Screensaver’ using the UP or DOWN buttons, press the OK
button to enter the ‘Auto Screensaver’ submenu.
5. Press the UP or DOWN buttons to select your desired duration. Then
press the OK button to confirm your selection (Off, 10 Seconds, 20
Seconds, 30 Seconds).
3.4.9 Auto Shutdown (Power Save)
This function sets the duration of time in which the camcorder will wait with
no user input before automatically power off the camcorder.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button twice to enter Options Setup Mode.
4. Select ‘Auto Shutdown’ using the UP or DOWN buttons, press the OK
button to enter the ‘Auto Shutdown’ submenu.
5. Press the UP or DOWN buttons to select your desired duration. Then
press the OK button to confirm your selection (Off, 1 Minute, 3 Minutes, 5
Minutes).
3.4.10 Time Watermark (Date and Time Stamp)
This function adds the date/time stamp to your videos and photographs.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button twice to enter Options Setup Mode.
4. Select ‘Time Watermark’ using the UP or DOWN buttons.
5. Press the OK button to turn Time Watermark On or Off, if the box has a
check mark then the Time Stamp is activated.
3.4.11 Beep Sound
This setting allows you to enable or disable the sound when pressing a
button.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button twice to enter Options Setup Mode.
4. Select ‘Beep Sound’ using the UP or DOWN buttons.
Press the OK button to turn Beep Sound On or Off, if the box has a check
mark then the Beep Sound is activated.