Minolta MN4KP1 - Page 19

ϯhƐŝŶŐdŚĞĂŵĐŽƌĚĞƌ

3.5.4 Reset to Factory Settings
Factory default settings can be restored in this menu. This function will not
delete the media stored on the memory card, and will only restore all of the
menu’s setting back to factory default settings.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button three times to enter Options Settings Mode.
4. Select ‘Reset to Factory Settings’ using the UP or DOWN buttons, press
the OK button to enter the ‘Reset to Factory Settings’ submenu.
5. Press the UP or DOWN buttons to select your desired duration. Then
press the OK button to confirm your selection (Confirmation, Cancel).
3.5.5 Firmware Version
This setting will allow you to see what firmware version is installed on your
camcorder.
1. Press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Options mode.
3. Press the MODE button three times to enter Options Settings Mode.
4. Select ‘Firmware Version’ using the UP or DOWN buttons, press the OK
button to enter the ‘Firmware Version’ submenu.
5. The firmware version will show on the screen, press the OK button to exit
the Firmware Version submenu.